RotorX Atom V3 is a 122mm Mini Quadcopter and weights less than 250 grams, it is very small and light. About such miniquadcopter, how to build it? This guide is tell you how to build a Rotorx Atom V3.
Before to build Rotorx Atom V3, you need prepare some Materials.
Quadcopter Materials:
FC, ESC's, T-Motors 1406kv Motors, OSD, VTX, FPV Camera, Frame, Canopy
DSMX Compatible Radio, Goggles
Motors, Props, Flight Controllers, ESC's, Canopies And OSD/VTX Boards;
You can buy these materials form Flitest.
Battery:
About batteries, you have two choice 3S Lipo pr 4S Lipo, if you want to use this quadcopter to racing, I advise you choose 4S Lipo.
I recommend you these two batteries:
3S Battery: Tattu 850mAh 4S 45C Lipo
Sales link:
4S Battery: Tattu 850mAh 3S 45C LIPO.
Sales link:
Tools:
2mm and 1.5mm hex driver
Solder
Soldering iron
Heat gun
Wire snips
Wire strippers
Loctite
Everything have prepared, new lets begin to build RotorX Atom V3.
First, solder the XT30 power cable on the base layer
Next, select your antenna and connect. Note: DO NOT power on without the antenna being in place because it can damage the VTX.
Attach the plastic base plate to the cube. This part helps protect from carbon and prevents shortages. To attach, use two short, flat screws in recessed holes to secure. Screw the positive nuts on the cube—they are marked with “+”. Then place double-sided tape on the bottom of the cube. This isolates the screws from the frame.
Use two plastic screws to secure the cube to the from into the “-“ nuts. Make sure you secure them firmly.
Tin the ESC solder pods.
Extend wires on motors. (Watch video)
Connect wires on front of quad
Attach motors to the frame with the longest screws and use Loctite.
Install receiver. As long as it fits under the canopy, anything goes. (Including: PPM, SBUS, Spektrum) There are three pads to solder to if your RX doesn’t plug in properly.
Attach the camera. It has three different mounts (15, 30 and 45 degrees). Only permanently glue in if you don’t want to change the tilt. Note: hot glue is a good option to use because it’s less permanent.
Plug camera into front left bottom plug.
Use long M3x12 screws to hold the camera in.
Install LED and route antennas.
Install canopy.
Ensure the wires aren’t pinched.
Route antenna.
Plug in USB and connect to BetaFlight. Plug in battery. Go to motor tab and test motor direction. If your motors aren’t correct, you can check in BLHELI.
Bind and configure the Atom V3.
Set-up switches and configure end points to the DX6.
To enter the OSD turn on quad and radio. Hold left on the yaw axis and count down. Navigate up and down with the pitch. Confirm with roll axis, which goes back or exits out of the configuration.
Install propellers–AND FLY!
IHere is a video about Rotorx Atom V3:
If you want to know more about these, you can go to visit http://rcfpvplane.com/diy-rotorx-atom-v3-build/ There are many guides about build drones.
没有评论:
发表评论